AKG PR 40 User Instructions page 14

3 Setting Up
3.1 Powering
To power the PR 40 portable
receiver you can use the supplied 1.5 V
AAA size dry batteries or 1.5 V AAA size
rechargeable batteries (not supplied).
3.2 Inserting/Replacing and Testing
Batteries (Fig. 3)
1. Depress the snap hook on the battery
compartment lid (1).
2. Pull the battery compartment lid (1)
down to remove it from the receiver.
Important: The foam pad on the inside
of the battery compartment lid (1)
holds the batteries in place. Do not
remove the foam pad. If you do, the
batteries will not be held in place
securely and may cause a rattling
noise.
14
Fig. 3: Inserting batteries.
3. If there are dead or defective batte-
ries inside the battery compartment,
remove the batteries.
4. Insert the supplied or new batteries
(2) into the battery compartment as
shown in fig. 3.
5. Set the ON/ OFF switch (3) to ON.
If the batteries are in good condition,
the BATT LED (4) will light green. If
the BATT LED (4) illuminates red, the
batteries will be dead within about 60
minutes. Replace the batteries with
new ones as soon as possible.
If the BATT LED (4) fails to illuminate
the batteries are dead. Insert new
batteries.
6. Slide the battery compartment lid (1)
onto the receiver against the direc-
tion of the arrow to the point that the
lid (1) will click shut.