Line Commands; Line; Table 23-7 Line Commands - SMC Networks TigerStack II SMC8926EM Management Manual

Line Commands

You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command Function

line

Identifies a specific line for configuration and starts the line
configuration mode
login Enables password checking at login
password Specifies a password on a line
timeout login Sets the interval that the system waits for a login attempt
response
exec-timeout Sets the interval that the command interpreter waits until user
input is detected
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts
Sets the amount of time the management console is inaccessible
*
silent-time
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
Sets the number of data bits per character that are interpreted and
*
databits
generated by hardware
Defines the generation of a parity bit
*
parity
Sets the terminal baud rate
*
speed
Sets the number of the stop bits transmitted per byte
*
stopbits
disconnect Terminates a line connection
show line Displays a terminal line's parameters
* These commands only apply to the serial port.
line
This command identifies a specific line for configuration, and to process subsequent
line configuration commands.
Syntax
line {console | vty}
• console - Console terminal line.
• vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration

Table 23-7 Line Commands

23
Line Commands
Mode Page
GC
LC
LC
LC
LC
LC
LC
LC
LC
LC
LC
PE
NE, PE
23-17
23-18
23-19
23-20
23-20
23-21
23-22
23-22
23-23
23-23
23-24
23-24
23-25
23-17