Chapter 21: Overview Of The Command Line Interface; Using The Command Line Interface; Accessing The Cli; Console Connection - SMC Networks TigerStack II SMC8926EM Management Manual

Chapter 21: Overview of the Command Line
Interface
This chapter describes how to use the Command Line Interface (CLI).
Note:
You can only access the console interface through the Master unit in the stack.

Using the Command Line Interface

Accessing the CLI

When accessing the management interface for the switch over a direct connection
to the server's console port, or via a Telnet connection, the switch can be managed
by entering command keywords and parameters at the prompt. Using the switch's
command-line interface (CLI) is very similar to entering commands on a UNIX
system.

Console Connection

To access the switch through the console port, perform these steps:
1. At the console prompt, enter the user name and password. (The default user
names are "admin" and "guest" with corresponding passwords of "admin" and
"guest.") When the administrator user name and password is entered, the CLI
displays the "Console#" prompt and enters privileged access mode
(i.e., Privileged Exec). But when the guest user name and password is entered,
the CLI displays the "Console>" prompt and enters normal access mode
(i.e., Normal Exec).
2. Enter the necessary commands to complete your desired tasks.
3. When finished, exit the session with the "quit" or "exit" command.
After connecting to the system through the console port, the login screen displays:
User Access Verification
Username: admin
Password:
CLI session with the SMC TigerStack II 10/100/1000 SMC8926EM/SMC8950EM
is opened.
To end the CLI session, enter [Exit].
Console#

Telnet Connection

Telnet operates over the IP transport protocol. In this environment, your
management station and any network device you want to manage over the network
must have a valid IP address. Valid IP addresses consist of four numbers, 0 to 255,
21-1