Adjusting The Volume (Master Gain); Adding Liveliness To The Sound (Dynamics Sound Control) - Roland F-110 Owner's Manual

Adjusting the Volume (Master Gain)

This parameter allows you to compensate for a markedly
reduced or increased level as a result of the EQ settings you
are using. There is probably no need to change this value if
you do not change the "EqL," "EqM" and "EqH" settings.
Also, if you are playing the F-110 through a connected
external system, there may be cases in which the volume
from your external system is too low even when the F-110's
volume is turned to the maximum setting. In such cases, you
can adjust the master gain setting as follows.
Adjusting the master gain will also affect the volume of the
internal speakers and headphones.
The sound may distort if you increase the volume
excessively.
1.
Hold down the [Reverb] button and press the
[Transpose] button.
The display will indicate "Fnc" and you'll be in Function
mode.
2.
Press and hold the [E. Piano] button and use the [–]
or [+] button to select "MAS."
3.
Release the [E. Piano] button to see the current
setting.
4.
Use the [–] [+] buttons to change the setting.
Setting Explanation
This adjusts the F-110's level. Negative values
reduce it, while positive value increase it.
-10–0–10
Always set this parameter in such a way as to
avoid distortion.
5.
Press the [Reverb] or [Transpose] button to leave
Function mode.
Adding Liveliness to the Sound
(Dynamics Sound Control)
You can add liveliness to the sound to give it superb clarity
and distinctness.
fig.PluMinEpi.eps_88
1.
Hold down the [Reverb] button and press the
[Transpose] button.
The display will indicate "Fnc," and you'll be in Function
mode.
fig.d-Fnc.eps_88
2.
Hold down the [E. Piano] button and use the [–] [+]
buttons to make the display indicate "dYn."
fig.d-dYn.eps_88
When you take your finger off the button, the display will
show the type of dynamics sound control.
fig.d-OFF.eps_88
3.
Use the [-] [+] buttons to select the desired sound
control setting.
Setting Explanation
OFF Dynamics sound control is turned off.
Creates a sound with boosted bass and
1 (Sharp)
treble.
Produces a sound with chords in the low
2 (Clear)
registers that are clear and distinct.
3 (Power) Creates a sound with boosted bass.
4.
Press the [Reverb] or [Transpose] button to leave
Function mode.
You will return to the normal screen.
Various Settings
47