Roland FR-2b Manual

r
FR-2/FR-2
Accessory Guide
Attaching the straps
Proceed as follows to attach the straps to your FR-2/FR-2b:
(1) Unpack the straps.
(2) Put the FR-2/FR-2b on a stable surface.
The connection panel must face down.
(3) Slide the upper end of one strap through the
holder ring (see the illustration).
The upper end is the part with the Velcro portions
and the clip.
(4) Fasten the strap's upper part to the Velcro layer
below it.
(5) Close the security clip to ensure that the strap
cannot come loose.
(6) Repeat steps (3)~(5) for the other strap.
The upper strap ends should look as follows:
(7) Turn the FR-2/FR-2b around (with the connection
panel on the left side, see below).
602.00.0272
(8) Slide the lower end of one strap through the
holder ring as shown.
(9) Slide the strap end through the upper eyelet of its
plastic buckle (see the illustration).
(10) Turn the strap end around and insert it into the
lower eyelet, then pull it tight.
RES 630-07 Accessory Guide E