Ricoh AficioSP C410DN Software Manual page 239

Parameter
keyphrase " phrase" val {1|2|3|4}
encval {1|2|3|4}
wepauth [open|shared]
rate [auto|11m|5.5m|2m|1m]
security {none|wep|wpa}
wpaenc {tkip|ccmp}
wpaauth {wpapsk|wpa}
Remote Maintenance by telnet
Value configured
You can specify the WEP key when entering
in ASCII.
With a 64-bit WEP, you can use 10 digit hex-
adecimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Spec-
ify the number to be registered with "val".
When a WEP is specified by key phrase, the
WEP specified by key is overwritten.
To use this function, set the same key
number and WEP key for all ports that trans-
mit data to each other.
You can omit the numbers with "val". The
key number is set to 1 when making these
omissions.
You can specify which of the four WEP keys
is used for packet encoding. "1" is set if a
number is not specified.
You can set an authorization mode when us-
ing WEP. The specified value and authorized
mode are as follows:
open: open system authorized (default)
shared: shared key authorized rate
You can set the IEEE 802.11b transmitting
speed.
The speed you specify here is the speed at
which data is sent. You can receive data at
any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m:2 Mbps fixed
1m: 1 Mbps fixed
You can specify the security mode.
none: No encryption(default)S
wep: WEP encryption
wpa: WPA encryption
You can specify WPA encryption key when
using WPA encryption.
tkip: TKIP (default)
ccmp: CCMP (AES)
You can specify the WPA authentication
mode when using WPA encryption.
wpapsk: WPA-PSK authentication(default)
wpa: WPA(802.1X) authentication
6
227