Ricoh Aficio SP C400DN Hardware Manual page 91

Label Paper
Printer setup
Printer driver setup
Enabled paper feeding tray Any input tray can be used.
Duplex printing
Additional cautions
Note
❒ If the printing result is badly wet or smudged, change the setting on the
printer's control panel as the following:
• Press the {Menu} key, select [Maintenance], [General Settings], and then select
[Label Paper]. Select one from [Label Paper 1], [Label Paper 2], or [Label Paper 3].
The greater number corresponds to the thicker setting.
The one of these items is normally detected automatically according to the
paper type you set. It is not necessary to change this setting when the print-
ing result has no problem.
OHP transparencies
Printer setup
Printer driver setup
Enabled paper feeding tray Any input tray can be used.
Number of sheets that can
be set
Duplex printing
Additional cautions
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [Label
Paper] for the selected tray's paper type.
Click [Labels] in the [Paper type:] list.
Make sure paper is not stacked higher than the upper limit mark
(T) inside the tray. Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Not possible
Print speed is slightly slower compared to plain paper.
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [OHP
(Transparency)] for the selected tray's paper type.
Click [OHP Transparency] in the [Paper type:] list.
• Tray 1: 100
• Tray 2, Tray 3 (Paper Feed Unit Type 4000): 100
• Bypass Tray: 100
Make sure paper is not stacked higher than the upper limit mark
(T) inside the tray. Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Not possible
• Print speed for OHP transparencies is slower than for plain pa-
per.
• Due to switching modes, the printer will be on standby for
thirty or forty seconds after the job was received.
• We recommend that you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.
Paper Recommendations
5
85