20.3 System setup menu
The following table describes the various options in the System Setup menu for your multifunction display.
Menu item
Position Mode
TD Setup
Simulator
Bearing Mode
MOB Data Type
232
Description
Determines how positioning data is displayed — as
Latitude/Longitude coordinates, or Loran TDs.
When the Position Mode (see above) is set to TDs, you can
specify the chain identifier, slave, and ASF values.
Enables or disables simulator mode, which allows you to practice
operating your multifunction display without data from a GPS
antenna, fishfinder (DSM sonar), or any other external unit.
Determines how all bearing and heading data is displayed in.
This does not affect how the chart or radar displays are drawn.
Determines whether positional data or dead reckoning is
displayed. Assuming that your vessel and the Man Over Board
(MOB) are subject to the same tide and wind effects, the dead
reckoning setting normally gives a more accurate course.
Options
• Lat/Long (default)
• TDs
Chain
• Various options, depending on cartography.
Slave 1/2
• Various options, depending on cartography.
ASF 1/2
• –09.9 to +09.9
• OFF (default)
• ON
• DEMO
• True (default)
• Magnetic
• Dead Reckoning (default)
• Position
E-Series Widescreen User reference