System Check And Initial Setup; System Check; Switch On And Initial Setup - Raymarine RayChart 630 Owner's Handbook Manual

Chapter 7: Installation

7.6 System Check and Initial Setup

Once you have installed your chartplotter and made all the connections, you
need to check and test your installation before using the system for navigation.
You may wish to read Chapters 2 to 6, and familiarize yourself with the
operation of the chartplotter, before performing the initial setup.

System Check

Before performing the power-on test, check the following:
• All securing screws are fully tightened
• All connections have been made
• All connecting wires are secured and protected as necessary
Note: If you are the boat owner and have performed the installation yourself,
you should ask your dealer to check the installation before going to sea.

Switch On and Initial Setup

1. Press the POWER key to switch on the display unit.
2. Press the CONTINUE soft key to clear the navigation notices.
3. Press the CHART soft key to clear the Fix Status screen, and any key to clear
the alarm message.
Note: A good fix is an indication that position data is being received.
4. If you have other equipment connected via the NMEA and NAVAIDS
ports, set the priority as follows:
a.
b.
c.
5. To speed up your initial position fix, select the FIX STATUS option from the
SET UP menu, press the INITIALIZE soft key, and use the trackpad to edit the
position data to match your current position. Refer to Section 6.2 for further
information.
You can perform additional customization, as described in Chapter 6.
Press MENU to display the menu options, use the trackpad or right-
most soft key to highlight the SYSTEM option on the SET UP menu,
ENTER ENTER
and press ENTER ENTER ENTER.
Use the trackpad to highlight the GPS Input selection option, press
ENTER to list the options.
Highlight the required option and press ENTER again.
Press CLEAR to return to the chart.
95