Pioneer VSX-33TX Operating Instructions Manual page 32

Initial Setup
SOURCE RECEIVER
VCR
DVD TV
MULTI CONTROL
CD CD-R TUN
1 2
LOUDNESS VIDEO SELECT
4 5
INPUT ATT DIGITAL NR
7 8
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10
0
EFFECT/CH SEL
RECEIVER
TV VOL TV
TV CONTROL
TVFUNC
4
CHANNEL
TUNE
5
ST
ENTER
TUNE
GUIDE
D.ACCESS BAND
& ‹
MPX DTV ON / OFF
¶ !
RETURN S.MODE CLEAR DTV INFO
RECEIVER DIRECT CONTROL
MIDNIGHT DSP STEREO
THX ADVANCED STANDARD MUTE
2
/ DTS
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
MULTI JOG
(Turn to select / Push to enter)
memo
If you have a subwoofer and like lots of bass, it may seem logical to select LARGE for your FRONT speakers and
leave the subwoofer selected. This may not, however, yield the best bass results. Depending on the size and
shape of your room you may actually experience a decrease in the amount of bass due to what is called "low
frequency cancellations." If you have a subwoofer, listen to the bass response with the FRONT speakers set to
LARGE and SMALL alternatively and let your ears judge which sounds best.
The safest option in this case is to route all the bass sounds to the subwoofer by selecting SMALL for the
FRONT speakers.
32
VCR
1 2
TVC
3
MULTI CH INPUT
6
FL DIMMER
9
DISC
ENTER
MASTER VOLUME
¢
ST
MENU
CLASS
*
DTV MENU
⁄
RDM
FUNCTION
Î
RETURN
Depending on your choices the sound will be routed differ-
ently, read below for detailed explanations.
FRONT (default setting is LARGE)
• Select SMALL to send bass frequencies to the subwoofer.
• Select LARGE if your speakers will reproduce bass frequencies
effectively or if you did not connect a subwoofer.
(If you select SMALL for the front speakers the subwoofer will
automatically be set to YES. Also, the center and surround
speakers cannot be set to LARGE if the front speakers are set to
SMALL. In this case, all bass frequencies are sent to the
subwoofer.)
CENTER (default setting is LARGE)
• Select LARGE if your speaker will reproduce bass frequencies
effectively.
• Select SMALL to send bass frequencies to the other speakers or
subwoofer.
• If you did not connect a center speaker select NO. In this case, the
center channel is output from the front speakers.
• If the front speakes are set to SMALL the CENTER speaker will
automatically set to SMALL.
SURROUND (default setting is LARGE)
• Select LARGE if your speakers will reproduce bass frequencies
effectively.
• Select SMALL to send bass frequencies to the other speakers or
subwoofer.
• If you did not connect SURROUND speakers select NO. In this
case, the sound of the surround channels is output from the front
and center speakers.
• If the FRONT speakers are set to SMALL, the SURROUND
speakers will automatically be set to SMALL.
SUBWOOFER (default setting is YES)
• Selected YES you connected a subwoofer.
• If you did not connect a subwoofer select NO. In this case, the
bass frequencies are output from the front or surround speakers.
• Choose the PLUS setting if you want stronger reproduction of
deep bass sounds.
• If you select PLUS the bass frequencies that would normally come
out the front and center speakers are all routed to the subwoofer.
5 Select "Sp Set End" with the 5¥∞ buttons
or MULTI JOG dial and press ENTER to go
to "Channel Delay".
Next, proceed to Channel Delay on the next page.
If you want to change a setting before proceeding
use the arrow buttons to go back.