Remote Control Of Other Components; Setting Up The Remote Control - Pioneer VSX-33TX Operating Instructions Manual

Audio/video multi-channel receiver
Hide thumbs Also See for VSX-33TX:
Table of Contents

Advertisement

Remote Control of Other Components

Setting Up the Remote Control

In addition to controlling the receiver, the supplied remote control can operate your other components (DVD,
MD, VCR, TV, LD, CD, etc.). If your component(s) are listed in the "Preset Code List", simply recall the
corresponding preset code.
Recalling Preset Codes
The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset
code is assigned, pressing the button will automatically set the remote to operate the respective component.
• Refer to "Preset Code List" on pages 73 to 77 for the components and manufacturers available.
memo
• Refer on pages 60 to 64 for detailed explanations on how to operate your other components.
SOURCE
RECEIVER
VCR
VCR
DVD
TV
4
1
2
MULTI CONTROL
CD
CD-R
TUN
TVC
1
2
3
VIDEO SELECT
MULTI CH INPUT
LOUDNESS
4
5
6
3
INPUT ATT
DIGITAL NR
FL DIMMER
7
8
9
REMOTE SETUP
SYSTEM SETUP SIGNAL SELECT
+10
DISC
0
ENTER
EFFECT/CH SEL
2
RECEIVER
TV VOL
TV
MASTER VOLUME
TV CONTROL
TVFUNC
4
¢
CHANNEL
TUNE
ST
ST
ENTER
TUNE
GUIDE
MENU
D.ACCESS
BAND
CLASS
&
*
MPX
DTV ON / OFF
DTV MENU
!
RETURN
S.MODE
CLEAR DTV INFO
RDM
RECEIVER DIRECT CONTROL
FUNCTION
MIDNIGHT
DSP
STEREO
THX
ADVANCED STANDARD MUTE
2
Î
/ DTS
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
1 Press RECEIVER
The STANDBY indicator goes out.
1
2 Press RECEIVER.
This switches the remote to the receiver control mode.
5
3 Press the REMOTE SETUP button and hold
for three seconds to select the preset
mode.
The LED will blink twice.
4 Press the MULTI CONTROL button for the
component you want to control.
Each button can be set to control one of the following
components.
: DVD/LD player or DVD Recorder, VCR
VCR
VCR
DVD
1
2
: TV , Satellite tuner or Cable TV tuner
TV
TVC
: CD player, CD-R, TAPE, MD, DAT
CD
CD-R
: FM/ AM tuner
TUN
5 Use the number buttons to enter the 4 digit
setup code.
The LED will blink after each digit is input and will blink twice
to confirm a valid code has been input.
If the LED shows one long blink it means an invalid code has
been input. Check the preset code list and try again. If you are
not able to input a preset code you can refer to page 56 to
teach the remote control individual commands.
Repeat steps 3 through 5 to assign preset codes for as
many components as necessary.
to turn the power on.
55

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite vsx-33tx

Table of Contents