Direct Function - Pioneer VSX-33TX Operating Instructions Manual

Direct Function

The direct function is a useful feature which allows you keep the receiver in one function (for example, CD)
while putting the remote control in a different function. This could let you, for example, use the remote control
to set up and listen to a CD on the receiver and then use the remote control to rewind a tape in your VCR while
you continue to listen to your CD player.
When the DIRECT function is ON any MULTI CONTROL button you press will change the function of both the
receiver and the remote control. When you turn the DIRECT function OFF, you can operate the remote control
without affecting the receiver. Thus you could switch the remote control the VCR and operate that component
while the receiver plays a different component.
SOURCE RECEIVER
VCR VCR
DVD TV
1 2
MULTI CONTROL
CD CD-R TUN TVC
4
1 2 3
LOUDNESS VIDEO SELECT MULTI CH INPUT
4 5 6
2
INPUT ATT DIGITAL NR FL DIMMER
7 8 9
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10 DISC
0
ENTER
EFFECT/CH SEL
1
RECEIVER
TV
TV VOL MASTER VOLUME
TV CONTROL
TVFUNC
4 ¢
CHANNEL
TUNE
ST ST
SOURCE RECEIVER
VCR VCR
DVD TV
1 2
MULTI CONTROL
CD CD-R TUN TVC
4
1 2 3
LOUDNESS VIDEO SELECT MULTI CH INPUT
4 5 6
2
INPUT ATT DIGITAL NR FL DIMMER
7 8 9
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10 DISC
0
ENTER
EFFECT/CH SEL
1
RECEIVER
TV VOL TV MASTER VOLUME
TV CONTROL
TVFUNC
4 ¢
CHANNEL
TUNE
ST ST
ENTER
To set a MULTI-CONTROL button to DIRECT OFF:
1 Press RECEIVER.
3
This switches the remote to the receiver control mode.
4
2 Press REMOTE SETUP and hold for three
4
seconds.
The LED will blink twice.
3 Press MULTI CONTROL button which you
want to set to OFF.
4 Press 9, 8, then 3.
The LED blinks twice to indicate the button has been cleared.
To set a MULTI-CONTROL button to DIRECT ON:
1 Press RECEIVER.
This switches the remote to the receiver control mode.
2 Press REMOTE SETUP and hold for three
3
seconds.
4
The LED will blink twice.
4
3 Press MULTI CONTROL button which you
want to set to ON.
4 Press 9, 8, then 2.
The LED blinks twice to indicate the button has been cleared.
TV CONT doesn't have this feature and thus can't use the
memo
DIRECT FUNCTION.
Using Other Functions
69