Pre-Rec; Shooting Guide - Panasonic HDC-HS100 Operating Instructions Manual

PRE-REC

This prevents you missing a shot.
This allows recording of the pictures and sound
to start approximately 3 seconds before the
recording start/stop button is pressed.
1
Press the PRE-REC button.
PRE-REC
[ ] appears on the screen and the unit
repeats the update by recording motion pictures
for about 3 seconds onto the built-in memory and
then deleting them.
Aim this unit at the subject and position it
securely.
Press the PRE-REC button again to cancel the
setting.
2
Press the recording start/stop
button to start recording.
Images and audio are recorded for about 3
seconds before pressing the recording start/
stop button.
There is no beep sound.
After recording starts, the PRE-REC setting is
cancelled.
To use the PRE-REC function again, press the
PRE-REC button again.
PRE-REC is cancelled in the following cases.
If you operate the mode dial.
If you open the SD card cover when the
[MEDIA SELECT] is set to [SD CARD] in
recording mode.
If you press the MENU button.
If you turn the unit off.
When the remaining time left for recording
motion pictures is less than 1 minute, PRE-
REC cannot be set.
If you start recording less than 3 seconds after
pressing the PRE-REC button, or while the
PRE-REC indication flashes within about
3 seconds after initiating the quick start
operation, motion pictures for 3 seconds
cannot be recorded.
40
VQT1U19
When the recording start/stop button is
pressed, image shake and operation sound
may be recorded.
The image when pressing the recording start/
stop button appears in thumbnail view, and it is
different from the image when starting
playback.

Shooting guide

PRE-REC
Message is displayed when this unit is moved
rapidly.
Select the menu. (F 24)
[ADVANCED]
[ON]
This function's default setting is [ON].
When "CAMERA PANNING IS TOO FAST."
appears, move the unit slowly while recording.
Set to [OFF] to turn off the message
indication.
Message will not appear while pausing the
recording. (Message will appear even if it is
pausing the recording if [DEMO MODE] is set
to [ON])
In some recording conditions, messages may
not appear.
[SHOOTING GUIDE]