Pre-Rec; Shooting Guide - Panasonic HDC-SD100 Operating Instructions Manual

PRE-REC

This prevents you missing a shot.
This allows recording of the pictures and sound
to start approximately 3 seconds before the
recording start/stop button is pressed.
1
Press the PRE-REC button.
PRE-REC
[ ] appears on the screen and the unit
repeats the update by recording motion pictures
for about 3 seconds onto the built-in memory and
then deleting them.
≥ Aim this unit at the subject and position it
securely.
≥ Press the PRE-REC button again to cancel the
setting.
2
Press the recording start/stop
button to start recording.
≥ Images and audio are recorded for about 3
seconds before pressing the recording start/
stop button.
≥ There is no beep sound.
≥ After recording starts, the PRE-REC setting is
cancelled.
≥ To use the PRE-REC function again, press the
PRE-REC button again.
≥ PRE-REC is cancelled in the following cases.
jIf you operate the mode dial.
jIf you open the SD card cover.
jIf you press the MENU button.
jIf you turn the unit off.
≥ When the remaining time left for recording
motion pictures is less than 1 minute, PRE-
REC cannot be set.
≥ If you start recording less than 3 seconds after
pressing the PRE-REC button, or while the
PRE-REC indication flashes within about
3 seconds after initiating the quick start
operation, motion pictures for 3 seconds
cannot be recorded.
≥ When the recording start/stop button is
pressed, image shake and operation sound
may be recorded.
40
VQT1T81
≥ The image when pressing the recording start/
Message is displayed when this unit is moved
rapidly.
Select the menu. (l 24)
PRE-REC
≥ This function's default setting is [ON].
When "CAMERA PANNING IS TOO FAST."
appears, move the unit slowly while recording.
≥ Set to [OFF] to turn off the message
≥ Message will not appear while pausing the
≥ In some recording conditions, messages may
stop button appears in thumbnail view, and it is
different from the image when starting
playback.

Shooting guide

[ADVANCED] # [SHOOTING GUIDE] #
[ON]
indication.
recording. (Message will appear even if it is
pausing the recording if [DEMO MODE] is set
to [ON])
not appear.