Quick Start; Quick Power On - Panasonic HDC-HS100 Operating Instructions Manual

Quick start

This unit will resume recording pause mode
about 0.6 seconds after the LCD monitor is
reopened.
When in quick start standby mode about
70% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
Rotate the mode dial to select
1
Set the LCD/EVF select switch to
LCD. (F 31)
2
Select the menu. (F 24)
[SETUP] [QUICK START]
3
Close the LCD monitor while the
mode dial is set to
The status indicator flashes green and the unit
goes into quick start standby mode.
The lens cover does not close.
4
Open the LCD monitor.
The status indicator lights red and the unit is
put into recording pause approx. 0.6 seconds
after it is turned on.
Set [QUICK START] to [OFF] to cancel the
quick start mode.
Quick start standby mode is cancelled if
about 5 minutes elapsed
mode dial is set to
unit is turned off
36
VQT1U19
Time for quick start will be more than 0.6
seconds slower in the following conditions.
When the digital cinema is used
When the unit is exposed to vibration or
shock
In the quick start mode, it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
.
the colour night view function is used, however,
the white balance of the scene last recorded is
retained.)
In the quick start mode, the zoom
magnification becomes 1
may differ from what it was before quick start
standby mode.
[ON] If [POWER SAVE] (F 26) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
.

Quick power on

(Only when recording to an SD card)
The unit is put into recording pause approx.
1.9 seconds when the mode dial is set to
from OFF.
Start time will not shorten if you are recording
to a HDD, or if there is no SD card inserted.
Rotate the mode dial to select
1
Select SD card as a media to
record from the menu. (F 24)
[MEDIA SELECT]
2
Select the menu. (F 24)
[SETUP]
This function's default setting is [ON].
Set [QUICK POWER ON] to [OFF] to cancel
the quick power on.
In the quick power on mode, the zoom
magnification becomes 1
may differ from what it was before turning
power off.
and the picture size
[SD CARD]
[QUICK POWER ON] [ON]
and the picture size
.