Palm Tungsten T2 Handbook page 367

Palm tungsten t2: user guide
Hide thumbs Also See for Tungsten T2:
Table of Contents

Advertisement

Click the Modem tab to display the modem settings and adjust the options as
5.
needed. For more information, see
later in this chapter.
If you are attached to a network, click the Network tab to display the network
6.
settings and adjust the options as needed. For more information, see
"Conducting network HotSync operations"
Click OK.
7.
To set the HotSync options on a Mac computer:
Double-click the HotSync Manager icon in the Palm folder.
1.
Click the HotSync Controls tab, and select any of the following options.
2.
Shown with Mac OS X
HotSync
Enabled/Disabled
Enable HotSync
software at system
startup
Show more detail
in HotSync Log
"Conducting modem HotSync operations"
Activates the transport monitor and prepares your Mac
computer to synchronize with your handheld. By default,
the transport monitor is enabled listen on USB and
PalmConnect whenever you start your computer.
If you are using Mac OS 9.1 and the optional serial HotSync
cradle/cable and you use the same serial port for other
devices besides the HotSync cradle/cable, disable the
transport monitor and then enable it manually only when
you connect the cradle/cable to perform a HotSync
operation.
Activates the transport monitor automatically each time
you start your computer. If this option is not selected, you
must open HotSync Manager and select the Enabled option
before you can perform a HotSync operation.
Includes more troubleshooting information in the log that is
generated when you perform a HotSync operation.
Selecting HotSync setup options
later in this chapter.
353

Advertisement

Table of Contents
loading

This manual is also suitable for:

P80860us - tungsten t2 - os 5.2.1 144 mhz

Table of Contents