Palm Tungsten T2 Handbook page 309

Tap Advanced.
4.
Select any of the following preferences:
5.
Types ahead and completes a recognized e-mail address. See
Enable Smart
Addressing
the procedure for creating new e-mail later in this chapter for
more information.
Determines how often e-mail messages in the trash are
Auto-Empty Mail
from Trash
automatically deleted. See
chapter for more information.
Sets the number of seconds to try to connect before timing
Timeout
out. This value can be any number greater than 0 seconds;
however, if you set the number too low, your connection
attempt may time out before you make a connection with the
e-mail service provider.
The default setting is 45 seconds. To change, tap the Timeout
field and enter a new value.
Automatically disconnects your remote connections after
Auto-Disconnect
each command. Each command you perform initiates a new
call to your ISP. This setting is not recommended if you plan
to perform multiple e-mail transactions in a short amount of
time.
Disconnects the connection to your e-mail service provider
Disconnect on
Exit
only after you leave the VersaMail application. This feature
is an alternative to Auto-Disconnect. This option keeps your
connection active while you perform multiple transactions
in the VersaMail application, but automatically disconnects
when you move on to a different application on your
handheld. If this option is not selected, you must manually
disconnect from your ISP.
Going beyond the basics
"Emptying the trash" later in this
295