Olympus IR-500 Reference Manual page 232

If a problem arises
Possible cause
The camera is in shooting mode.
The brightness of the monitor is not
adjusted properly.
The camera is connected to a TV.
( The "ERASE" or "ALL ERASE" setting does not operate.
The image(s) are protected.
( The image does not appear on the TV screen even if the camera and TV are connected
through the cradle.
The camera's video output signal type
is set incorrectly.
Wrong video input on the TV is
selected.
( The camera enters clock mode when set on the cradle.
The camera is set on the cradle with the
multi-swing display closed.
( The picture is too dark.
The flash was blocked by your finger.
232
Corrective action
Set the mode dial to q.
Adjust the monitor's brightness with
the "s" (monitor brightness
adjustment) settings of the setup menu.
If the AV cable is connected to the
camera through the cradle, the monitor
does not turn on.
Set the "0" (protect) setting of the
image(s) to "OFF."
Set the correct video signal type in
accordance with the local system.
Set the TV to the video input to which
the cradle is connected.
The camera automatically enters clock
mode when set on the cradle with the
display closed. To operate the camera
on the cradle, open the display.
Hold the camera correctly so that the
flash is not blocked by your finger.
Ref.
page
P.96
P.167
—
P.126
P.170
—
—
P.41