3
Connect the supplied USB cable to the cradle's USB terminal, then set
the camera on the cradle with the multi-swing display opened.
A / V OUT
(MONO)
-
+
DC IN 5V
The camera turns on and the "PC / PRINTER" screen appears.
4
Press a/c to select "SEL. PRINT," then press 9.
The "PRINT MODE SELECT" screen appears after a while. Go to "Procedures for
printing" (g page 196).
PC / PRINTER
PC
PRINT
SEL.PRINT
EXIT
SELECT
Notes
• If "PC" is selected accidentally, start over from step 1.
• If you select "PRINT" when a non-Dock&Done-compatible printer is connected, the error message
"DOCK&DONE PRINTER IS NOT CONNECTED" appears.
Printing with a PictBridge-compatible printer
USB
GO
Camera connector dial
Turn the dial to select this mark.
195