Select Paper; Original Type - Kyocera KM-C2520 Advanced Operation Manual

Copy Functions
Setting Functions
This section explains the copying functions available when using Job Build.

Select Paper

Select the paper size.
1 Press [Basic]. On the next screen, press
[Select Paper].
2
Select the MP tray or a cassette and press [Close].

Original Type

Select the original type according to type of original being scanned. The following original types are
available.
Original Type
1 sided (1-sided)
2 sided (2-sided)
Book
1 Press [Basic]. On the next screen, press [Original Type].
2 Select [1 sided] ([1-sided]), [2 sided] ([2-sided]) or [Book].
When selecting [2 sided], check the binding direction and be sure that the originals are placed in the
correct orientation.
When selecting [Book], be sure that the binding direction is correct.
NOTE: [2 sided] ([2-sided]) is displayed when the optional document processor is installed.
3
Press [Close].
1 sided/2 sided Copying
Select either [1 sided Copy] ([1-sided Copy]) or [2 sided Copy] ([2-sided Copy]) for the finish type.
1
Press [Basic]. On the next screen, press [1 sided/2 sided] ([1-sided/2-sided]).
NOTE: 1 sided/2 sided copy selection is common to all steps. It may only be configured as the first
step.
2
Press [1 sided Copy] ([1-sided Copy]) or [2 sided Copy] ([2-sided Copy]) and from Finished select
the binding direction.
1-62
Ready to Job build.
Place originals then press Start key.
Job Build
11×8½"
Select
Paper
Offset
Finished
Basic
Description
Single sided sheet original.
2-sided sheet original.
Magazine or book originals with facing pages.
( Full-Color
- Step
1 sided Copy
1 sided
Original 1 sided/
Type 2 sided
Auto % Top Edge
Reduce Orig. Set
/Enlarge Direction
Quality Edit
)
1 sided copy-Left
Finished page #: