Proof And Hold - Kyocera KM-C2520 Advanced Operation Manual

4
Press [ ] or [ ] to select the user and
press [Next].
5 Press [ ] or [ ] to select the job and
press [Next].
NOTE: Select the job and press
[Delete] to delete the selected job.
6
Press [+], [–] or numeric keys to set the desired number of copies and press [Printing].
Processing message is displayed and printing begins.
7 When printing is complete, the screen returns to printer mode.

Proof and Hold

By setting Proof and Hold in the printer driver and specifying the required number of copies, this
device prints a single copy and saves the document data to the hard disk or RAM disk. Use the
operation panel to print the remaining copies. The number of copies can be changed at this time.
When the power is switched off, jobs saved in this mode are erased.
Printing remaining Job Hold copies
The printing operation is the same as Quick Copy. For Quick Copy printing procedures, refer to
Quick Copy on page 3-34.
Private Print /Job Storage
Private Print is feature to print from the operation panel by entering the same 4 digit code as entered
in the print driver when starting printing. Data is erased after printing is complete.
Job Storage saves the print data to the hard disk. The data remains on the hard disk to be printed
any number of times, even after printing is complete or the power is switched off. The feature can be
used with or without an access code. For either driver setting method, refer to the Kyocera
Extended Driver User Guide.
1
Press the Printer key.
2
Press [e-MPS].
3 Press [Private/Stored].
name.
User Up
Down
Job Up
Down
Select item.
e-MPS
List of
Quick Copy
VMB
Private/ List of
Stored Code JOB
Print VMB
Data Tray
Printer Settings
Cancel
Next
Cancel
Delete
Next
Configu-
ration
3-35