Intermec EasyCoder PM4i User Manual page 79

General Paper Type Settings Guide (Thermal Transfer)
EasyCoder PM4i Printer User's Guide (Fingerprint Version)
Ribbon
Constant
Type
Wax (Europe) 80
Wax (U.S.A) 65
Wax/Resin 90
(Europe)
Wax/Resin 75
(U.S.A.)
Resin 100
(Europe)
Resin 90
(U.S.A.)
The Ribbon Sensor parameter is read-only. When performing a
Testfeed or when pressing the Enter key when the Ribbon Sensor
menu is displayed, the printer will feed out some media and
autoadjust the sensor. The resulting setting is displayed in the
menu.
The Low Diameter parameter specifies the diameter of the
ribbon supply roll, where SYSVAR(26) switches from 0 to 1.
SYSVAR(26) = 0 means that there is still a sufficient supply of
ribbon, whereas SYSVAR(26) = 1 means that it is time to
consider replacing the ribbon supply. The diameter is expressed
in millimeters (1 mm = 0.04 in.) and an accuracy of ±3 mm can
be expected. Note that this setting has little effect unless
SYSVAR(26) is read by a Fingerprint program. However, Error
1083 "Ribbon Low" is reported at every tenth printing
operation. By default, the low diameter is 0, that is, the ribbon
low function is disabled.
Chapter 6 — Setting Up the Printer
Ribbon Max Print
Factor 8 dots/mm
25 150
25 150
25 150-200
25 150-200
30 200
30 200
Speed
11.81 dots/mm
125
125
125-150
125-150
150
150
63