Roll Media - Datamax I-4206 Operator's Manual

3.1.1

Roll Media

This loading method is for roll type media applications. To load:
Slide the Roll Media
onto the Media Hub
until it rests against the
Backstop.
Route the media as
shown: under
Media Idler, through
the Media Sensor, then
out the front of the
printer.
Raise and slide the
Media Guide over until
it rests lightly against the edge of the media.
Position the Media Sensor; see Section 3.2.
If your application uses thermal transfer media, load ribbon (see Section
3.3); otherwise continue.
Lower the Printhead Assembly and rotate the Printhead Latch completely
back into the locked position. Close the Access Cover.
Turn 'On' the printer. After 'Ready is displayed, press and hold the FEED
Key until at least one label gap or mark is advanced; see Section 3.4.
If using less than full width media, adjust the Leveling Cam; see
Section 5.1.1.
18
the
I-Class