Loading Media - Datamax OC2 BT Technical Manual And User Manual

Loading media

The OC-2 series of printers are designed to print receipt paper
and label media, as follows:
Media Guidelines
Media width
Roll capacity diameter
Media types
Load media as follows:
1. Position the printer so that the Datamax-O'Neil logo is
facing you (Figure 18).
2. Press the printhead release and open the printer (Figure
19).
Figure18
3. Place the paper roll between the paper roll holders, as
shown in Figure 20. Make sure the paper exits over the roll
and is firmly in place.
4. Unroll enough paper so that paper exits the printer (Figure
21).
5. Verify the media exits straight and is against the right-
hand edge.
S
ETTING UP YOUR PRINTER
Receipt Paper: 2.25"
Label Media: 2.25"
Receipt Paper: 2.25"
Label Media: 2.25"
Receipt paper media, thermal paper.
* Depending on the type of media
used, you may need to configure your
printer. For more information, see
"Configuring the printer" on page 10.
Figure19
7