Loading Media - Datamax I-4206 Operator's Manual

3.1 Loading Media

Begin loading as follows:
Raise the Access Cover.
Rotate the Printhead Latch forward and raise the Printhead Assembly.
Slide the Media Guide out away from the frame and then lower it to the
down position.
If using roll media, the Media Hub can accept 3.0-inch (76mm) and 1.5-
inch (38mm) cores. To use 1.5-inch cores, first slide off the 3 Inch Hub by
grasping and then pulling it firmly outward.
Proceed according to the type of media you are using: go to Section 3.1.1
for Roll Media or go to Section 3.1.2 for Fan-Fold Media.
I-Class 17