Speaker - HP xw3100 Service And Technical Reference Manual

Removal and Replacement Procedures

5.16 Speaker

Sound power level
Operation:
Stand-by/Idle:
Sound pressure level
Operation:
Stand-by/Idle:
To install the speaker:
1. Prepare the workstation for disassembly (Section 5.1).
2. Remove the workstation access panel (Section 5.5).
3. Rotate the drive cage to its upright position.
4. Remove the expansion card cage (Section 5.9).
5. Disconnect the speaker wire from the system board.
6. Carefully cut the cable tie that secures the speaker cable to the power supply cable bundle.
Ä
CAUTION: Be careful when cutting the cable tie not to cut any cables.
7. Remove the power supply from the chassis (Section 5.17).
8. Remove the two screws that secure the speaker to the chassis.
9. Slide the speaker towards the rear of the chassis and down to remove it.
To install the speaker, reverse the removal procedures.
5–30
Hard Drive/48X CD-ROM
Hard Drive/48X CD-ROM
338611-001 Service and Technical Reference Guide, xw3100
LWAd (B)
4.2/5.4 Bels
3.9 Bels
dB
29/44 dBA
26 dBA