Removal and Replacement Procedures
5.12 Power Switch Assembly
1. Prepare the workstation for disassembly (Section 5.1).
2. Remove the workstation access panel (Section 5.5).
3. Disconnect the power switch/LED cable from the system board.
4. Carefully cut the cable tie that secures the power switch cable to the power supply cable
cable bundle.
Ä
CAUTION: Be careful when cutting the cable tie not to cut any cables.
5. Squeeze the switch holder retaining clips together at the front of the chassis 1 and push the
switch assembly out of the chassis 2.
To install the power switch assembly, reverse the removal procedure.
5–24
338611-001
Service and Technical Reference Guide, xw3100