3Optical Drive - HP xw3100 Service And Technical Reference Manual

Removal and Replacement Procedures
Item Description
One standard 3.5-inch, one-third
1
height bay (1.44-MB diskette drive
shown)*
5.25-inch drive bay for optional
2
drives.
*If the workstation has a 1.44-MB diskette drive installed, it will be configured with a diskette
drive bezel as shown in the illustration. If the workstation contains an empty 3.5-inch drive bay,
then a bezel blank will be installed on the workstation instead. If you do not have a drive in this
slot, you may choose to install a 3.5-inch device (such as a diskette drive or hard drive) later on.
However, to install a 3.5-inch device other than a diskette drive or hard drive, you must order the
3.5-inch device bezel to provide proper air flow within the chassis.
To verify the type and size of the storage device installed in the workstation, run Computer
Setup.
5.10.3 Optical Drive
Ä
CAUTION: All removable media should be taken out of the drives before removing the drive from the
workstation.
An optical drive is a CD-ROM, CD-RW, DVD-ROM, Combo, or DVD+RW drive.
1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock
(Section 5.2).
2. Prepare the workstation for disassembly (Section 5.1).
3. Remove the workstation access panel (Section 5.5).
4. Remove the front bezel (Section 5.6).
5. Raise the Easy Access drive bay (bay 2 area) to the upright position.
6. Disconnect the audio, signal, and drive power cables from the drive. The other end of the
cables should remain connected to the system board.
7. Return the Easy Access drive bay to the down position.
5–16
Drive Positions
Item
3
338611-001 Service and Technical Reference Guide, xw3100
Description
Internal 3.5-inch, one-third height
bay for hard drive