HP b2600 Technical Reference page 51

4. Connect the CD drive power cable, control cable, and audio cable (if an audio card is
present). See Figure 3-17. Note that these cables are keyed for easy replacement.
Figure 3-17. Connecting the CD Drive's Cables
Audio Cable
5. Replace the back cover on the CD drive bay by inserting the hinge tabs located on the
CD drive bay into their slots on the CD drive bay's back cover. Next, rotate the back
cover toward the CD drive bay until the retainer snaps are in place. See Figure 3-18.
Also, note the manner in which the audio, power and control cables were neatly fed
through the raised opening in the CD drive bay's back cover.
Figure 3-18. Replacing the CD Drive Bay's Back Cover
Hinge Tabs
and their
Slots
Chapter 3
Control Cable
Back Cover
Retainer
Snap
Remove/Replace System Components
Removing/Replacing System Components
Power Cable
Control
Power
Cable
Cable
Audio
Cable
Retainer
Snap
51