HP b2600 Technical Reference page 178

DC Power Supply
Removing the DC Power Supply
3. Disconnect the power supply cables from the system board by pressing in on the latch retainers
and pull the cable connector out of the system board connector. See
Figure E-4 Disconnect the Power Supply Cables
Power Supply
Cables
System Board
4. Unscrew the four power supply mounting screws located on the back of the system. See
Note that there is a power supply support arm that fits into a slot on the system divider
E-5
panel. This support arm prevents the supply from falling onto the system board while you are
unscrewing the mounting screws
Figure E-5 Unscrewing the Four Power Supply Mounting Screws
178
Component Heat Sink
Power Supply Mounting Screws
Figure E-4
Power Supply
Power Supply
Support Arm
System Divider
Panel
Appendix E
Figure