HP b2600 Technical Reference page 110

Boot Console Handler
Displaying and Setting Paths
To set a system path to a new value, follow the directions in the section "Accessing the Boot
Console Handler" found in this chapter, and type the following at the prompt:
Main Menu: Enter command > path path_type path [Enter]
where path_type is one of the path types listed in Table 4-1. and path is the specification
of the path in Mnemonic Style Notation (as described in Table 4-2.). For example, to set the
primary boot path to a FWSCSI disk with an ID of 6.0, follow the directions in "Accessing
the Boot Console Handler" on, and then type the following at the prompt:
Main Menu: Enter command > path pri fwscsi.6.0 [Enter]
110 Chapter 4