Installing Blade; Guard Assembly - Grizzly G0501 Instruction Manual

Installing Blade

Guard Assembly

The blade guard assembly parts have changed,
but the location is still the same. Refer to the
photographs in the manual for the installation
location.
To install the blade guard:
1. Remove the four bolts and lock washers from
the side of the motor cabinet.
2. Position the lower support arm (Figure 1)
over the holes in the motor cabinet and
secure the arm with the bolts and lock wash-
ers removed in Step 1.
Figure 1. Support arms.
-2-
5.
Remove the cap screws in the end of the
upper support arm (Figure 1), thread them
through the holes in the swing arm (Figure
2), and secure the swing arm to the upper
support.
Note: Get assistance holding the swing arm
while securing it to the support.
Figure 2. Holes for securing the swing arm.
6.
Remove the cap screws under the blade
guard and a cap screw at the front.
7. Position the clear blade shield guide holes
under the blade guard arm (Figure 3)
and secure the shield with the cap screws
removed in Step 6.
Note: Overtightening cap screws may crack
the blade shield.
Figure 3. Clear blade shield installed.
G0501 Manual Update