Table of Contents
Advertisement
Installing Blade
To reduce risk of injury, always disconnect
power to saw before changing blades. Since
blade is sharp, use extra care and wear
gloves when installing it.
Review this section, even if your saw blade came
pre-installed.
To remove and install blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Unlock cutting head by pulling head release
knob (see Figure 30).
Figure 30. Releasing cutting head from down
position.
Model T31634/T31635 (Mfd. Since 8/19)
Head Release
Knob
3.
Pull back lower blade guard, as pictured in
Figure 31, to reveal cover plate screw.
Lower
Blade Guard
Figure 31. Cover plate screw location.
4.
Loosen screw enough to allow cover plate
and lower blade guard to move backward to
reveal arbor bolt (see Figure 32).
Cover Plate
Figure 32. Revealed arbor bolt.
5.
Push in arbor lock (see Figure 33) and rotate
existing blade until it locks in place (or rotate
arbor if no blade is installed).
Figure 33. Arbor lock location.
Cover Plate
Screw
Arbor Bolt
Arbor Lock
-25-
Advertisement
Table of Contents
