Table of Contents
Advertisement
TW100-BRV304 User Guide
Firewall Rules
VPN
Timezone
Timezone
Enable Daylight
Saving
E-Mail Logs
Send E-mail alert
E-mail Logs
Send
E-mail Address
Subject
SMTP Server
Port No.
Syslog Server
Enable Syslog
Syslog Server
Include
If enabled, the log will details of packets blocked by user-defined
Firewall rules. Logging can be set for each rule individually.
Only rules which have logging enabled will be included.
If enabled, the VPN log will record incoming and outgoing VPN
connections.
Select the correct Timezone for your location. This is required for
the date/time shown on the logs to be correct.
If your location uses Daylight Saving, you should enable this
when daylight saving starts, and disable it when daylight saving
finishes.
If enabled, an E-mail will be sent immediately if a DoS (Denial of
Service) attack is detected. If enabled, the E-mail address infor-
mation must be provided.
You can choose to have the logs E-mailed to you, by enabling
either or both checkboxes. If enabled, the Log will send to the
specified E-mail address. The interval between E-mails is deter-
mined by the "Send" setting.
Select the desired option for sending the log by E-mail.
•
When log is full - The time is not fixed. The log will be sent
when the log is full, which will depend on the volume of traf-
fic.
•
Every day, Every Monday ... - The log is sent on the
interval specified.
•
If "Every day" is selected, the log is sent at the time
specified.
•
If the day is specified, the log is sent once per week, on
the specified day.
•
Select the time of day you wish the E-mail to be sent.
•
If the log is full before the time specified to send it, it
will be sent regardless of the day and time specified.
Enter the E-mail address the Log is to be sent to. The E-mail will
also show this address as the Sender's address.
Enter the text string to be shown in the "Subject" field for the E-
mail.
Enter the address or IP address of the SMTP (Simple Mail Trans-
port Protocol) Server you use for outgoing E-mail.
Enter the port number used to connect to the SMTP Server. The
default value is 25.
If enabled, log data will be sent to your Syslog Server.
Enter the IP address of your Syslog Server.
Select the logs you wish to be included.
62
Advertisement
Table of Contents
