Table of Contents
Advertisement
Login
Login Method
Login User Name
Login Password
RAS Plan
Server IP Address
Connect
automatically
Disconnect
after Idle
MAC Address
MAC Address
If your ISP does not use a login method (username, password) for
Internet access, leave this at the default value "None (Direct connec-
tion)"
Otherwise, check the documentation from your ISP, select the login
method used, and enter the required data.
•
PPPoE - this is the most common login method, widely used
with DSL modems. Normally, your ISP will have provided some
software to connect and login. This software is no longer re-
quired, and should not be used.
•
PPTP - this is mainly used in Europe. You need to know the
PPTP Server address as well as your name and password.
•
Big Pond Cable - for Australia only.
•
SingTel RAS - for Singapore only.
The User Name (or account name) provided by your ISP.
Enter the password for the login name above.
For SingTel customers only, select the RAS plan you are on.
If using PPTP or Big Pond Cable, enter the IP address of your ISP's
server.
If Enabled (default), a connection will automatically be made as
required. If disabled, you need to establish the connection manually,
using the Connect button on the Connection Details screen (accessed
from the Status screen).
Enable this if you wish an idle connection to be terminated.
If enabled, enter the idle time-out period (in minutes) in the field
provided. After the connection to your ISP has been idle for this time
period, the connection will be terminated.
Also called Network Adapter Address or Physical Address. This is a
low-level identifier, as seen from the WAN port.
Normally there is no need to change this, but some ISPs require a
particular value, often that of the PC initially used for Internet access.
You can use the Copy from PC button to copy your PC's address into
this field, the Default button to insert the default value, or enter a
value directly.
Setup
15
Advertisement
Table of Contents
