Monitoring And Maintaining Tunneling Status - Cisco WS-C3020 Software Configuration Manual

Monitoring and Maintaining Tunneling Status

Monitoring and Maintaining Tunneling Status
Table 15-2
Layer 2 protocol tunneling.
Table 15-2 Commands for Monitoring and Maintaining Tunneling
Command
clear l2protocol-tunnel counters
show dot1q-tunnel
show dot1q-tunnel interface interface-id
show l2protocol-tunnel
show errdisable recovery
show l2protocol-tunnel interface interface-id
show l2protocol-tunnel summary
show vlan dot1q tag native
For detailed information about these displays, see the command reference for this release.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
15-18
shows the privileged EXEC commands for monitoring and maintaining IEEE 802.1Q and
Purpose
Clear the protocol counters on Layer 2 protocol tunneling ports.
Display IEEE 802.1Q tunnel ports on the switch.
Verify if a specific interface is a tunnel port.
Display information about Layer 2 protocol tunneling ports.
Verify if the recovery timer from a Layer 2 protocol-tunnel error disable
state is enabled.
Display information about a specific Layer 2 protocol tunneling port.
Display only Layer 2 protocol summary information.
Display the status of native VLAN tagging on the switch.
Chapter 15 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
OL-8915-03