Troubleshooting Dynamic-Access Port Vlan Membership; Vmps Configuration Example - Cisco WS-C3020 Software Configuration Manual

Chapter 11 Configuring VLANs

Troubleshooting Dynamic-Access Port VLAN Membership

The VMPS shuts down a dynamic-access port under these conditions:
•
•
To re-enable a disabled dynamic-access port, enter the shutdown interface configuration command
followed by the no shutdown interface configuration command.

VMPS Configuration Example

Figure 11-5
dynamic-access ports. In this example, these assumptions apply:
•
•
•
•
•
OL-8915-03
The VMPS is in secure mode, and it does not allow the host to connect to the port. The VMPS shuts
down the port to prevent the host from connecting to the network.
More than 20 active hosts reside on a dynamic-access port.
shows a network with a VMPS server switch and VMPS client switches with
The VMPS server and the VMPS client are separate switches.
The Catalyst 6500 series Switch A is the primary VMPS server.
The Catalyst 6500 series Switch C and Switch J are secondary VMPS servers.
End stations are connected to the clients, Switch B and Switch I.
The database configuration file is stored on the TFTP server with the IP address 172.20.22.7.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring VMPS
11-33