Creating An Rspan Destination Session And Configuring Incoming Traffic - Cisco WS-C3020 Software Configuration Manual

Configuring SPAN and RSPAN
This example shows how to configure VLAN 901 as the source remote VLAN and port 1 as the
destination interface:
Switch(config)# monitor session 1 source remote vlan 901
Switch(config)# monitor session 1 destination interface gigabitethernet0/1
Switch(config)# end

Creating an RSPAN Destination Session and Configuring Incoming Traffic

Beginning in privileged EXEC mode, follow these steps to create an RSPAN destination session, to
specify the source RSPAN VLAN and the destination port, and to enable incoming traffic on the
destination port for a network security device (such as a Cisco IDS Sensor Appliance).
For details about the keywords not related to incoming traffic, see the
Session" section on page
been configured.
Command
Step 1 configure terminal
Step 2
no monitor session {session_number | all |
local | remote}
Step 3
monitor session session_number source
remote vlan vlan-id
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
27-20
27-19. This procedure assumes that the RSPAN VLAN has already
Purpose
Enter global configuration mode.
Remove any existing SPAN configuration for the session.
Specify the RSPAN session and the source RSPAN VLAN.
For session_number, the range is 1 to 66.
For vlan-id, specify the source RSPAN VLAN to monitor.
Chapter 27 Configuring SPAN and RSPAN
"Creating an RSPAN Destination
OL-8915-03