Cisco SR520-FE-K9 Administration Manual page 28

Setting up the Interfaces of the Services Ready Platforms
Setting up the WAN Interface
NOTE
STEP 7
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
When using the interface failover feature, the Interface Default Route automatically
selects the subinterface that is used to pass traffic redirected from a failed
interface.
To view the interface information, select a WAN interface from the WAN Interface
List. The WAN Interface Detail area displays information about the interface as
described in the table below.
WAN Interface Detail Settings
Name Value
Link Status Interface status; connected or disconnected.
IP Address Public IP address of the interface.
Netmask Subnet mask.
Gateway IP address of the ISP server.
Host Name Hostname, if applicable.
Domain Name Domain name, if applicable.
MTU Type Auto or Custom.
MTU Size Current MTU size. This value is blank if set to Auto.
DNS 1,2,3 IP addresses of the DNS servers, if configured.
VLAN If enabled, a IEEE 802. 1 q VLAN header is added to outbound
Encapsulation traffic, allowing some Service Providers to control quality of
service based on associated IEEE 802. 1 p priority values.
VLAN ID VLAN ID used if VLAN Encapsulation is enabled.
4
28