Cisco SR520-FE-K9 Administration Manual page 181

Configuring Voice
Configuring Voice Settings
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Message Waiting
Accept Media
Loopback Request
Media Loopback Mode
Media Loopback Type
The user can also manually modify it to clear or set
the flag. Setting this value to yes can activate stutter
tone and VMWI signal. This parameter is stored in
long term memory and will survive after reboot or
power cycle.
The default is no.
Controls how to handle incoming requests for
loopback operation. Choices are: Never, Automatic,
and Manual, where:
• never—never accepts loopback calls; reply 486
to the caller
• automatic—automatically accepts the call
without ringing
• manual—rings the phone first, and the call must
be picked up manually before loopback starts.
The default is Automatic.
The loopback mode to assume locally when making
call to request media loopback. Choices are: Source
and Mirror. The default is Source.
NOTE If the SRP answers the call, the mode is determined
by the caller.
The loopback type to use when making call to
request media loopback operation. Choices are
Media and Packet. The default is Media.
Note that if the SRP answers the call, then the
loopback type is determined by the caller (the SRP
always picks the first loopback type in the offer if it
contains multiple type).
6
181