Cisco SR520-FE-K9 Administration Manual page 132

6
132
Resync Periodic
Resync Error Retry
Delay
Forced Resync
Delay
Resync From SIP
Resync After
Upgrade Attempt
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
The time interval between periodic resyncs with the
provisioning server. The associated resync timer is
active only after the first successful sync with the server.
Set this parameter to zero to disable periodic resyncing.
The default is 3600 seconds.
Resync retry interval (in seconds) applied in case of
resync failure.
The device has an error retry timer that activates if the
previous attempt to sync with the provisioning server
fails. The device waits to contact the server again until
the timer counts down to zero.
This parameter is the value that is initially loaded into the
error retry timer. If this parameter is set to zero, the
device immediately retries to sync with the provisioning
server following a failed attempt.
The default is 3600 seconds.
Maximum delay (in seconds) the SPA waits before
performing a resync.
The device does not resync while one of its phone lines
is active. Because a resync can take several seconds, it
is desirable to wait until the device has been idle for an
extended period before resyncing. This allows a user to
make calls in succession without interruption.
The device has a timer that begins counting down when
all of its lines become idle. This parameter is the initial
value of the counter. Resync events are delayed until this
counter decrements to zero.
The default is 14,400 seconds.
Enables a resync to be triggered via a SIP NOTIFY
message.
The default is Yes.
Triggers a resync after every firmware upgrade attempt.
The default is Yes.
Configuring Voice
Configuring Voice Settings