Cisco SR520-FE-K9 Administration Manual page 150

6
150
CWCID Deact Code
Dist Ring Act Code
Dist Ring Deact
Code
Speed Dial Act Code
Paging Code
Secure All Call Act
Code
Secure No Call Act
Code
Secure One Call Act
Code
Secure One Call
Deact Code
Conference Act
Code
Attn-Xfer Act Code
Modem Line Toggle
Code
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
Disables call waiting, caller ID generation.
The default is *45.
Enables the distinctive ringing feature.
The default is *26.
Disables the distinctive ringing feature.
The default is *46.
Assigns a speed dial number.
The default is *74.
Used for paging other clients in the group.
The default is *96.
Makes all outbound calls secure.
The default is *16.
Makes all outbound calls not secure.
The default is *17.
Makes the next outbound call secure. (It is redundant if
all outbound calls are secure by default.)
The default is *18.
Makes the next outbound call not secure. (It is redundant
if all outbound calls are not secure by default.)
The default is *19.
If this code is specified, the user must enter it before
dialing the third party for a conference call. Enter the
code for a conference call.
If the code is specified, the user must enter it before
dialing the third party for a call transfer. Enter the code
for a call transfer.
Toggles the line to a modem. The default is *99. Modem
pass-through mode can be triggered only by pre-dialing
this code.
Configuring Voice
Configuring Voice Settings