Table of Contents
Advertisement
Table 5-1
RP Alphanumeric LED Display Messages (Continued)
1
LED Display
Indications
TLB
Initialize TLB
INIT
CACH
Initialize CPU data and instruction cache
INIT
CACH
Enable CPU cache parity
PARY
MEM
Initialize main memory
INIT
NVRAM
Size of the NVRAM
SIZE
PCMC
Initialize the PCMCIA
INIT
EXIT
Exit the initialization sequence
INIT
IOS
The Cisco IOS software is up and running
UP
MSTR
The RP is enabled and recognized by the system
RP
1. The messages shown do not indicate a specific sequence.
2. Some messages appear briefly (millisecond duration); others last several seconds.
— If the power supplies and blowers appear operational but none of the RP LEDs or
displays are on, suspect that the RP has not been properly installed or that the
+5 VDC output from the power supplies is faulty. Turn the power supply power
switch OFF (STANDBY on an AC-input power supply) on each power supply,
loosen the two captive screws on the top and bottom of the RP faceplate, and use
the ejector levers to eject and reseat the RP. Tighten the captive screws, then power
up the system by turning the power supply power switches to ON (|).
Troubleshooting the Processor Subsystem
2
Troubleshooting the Installation 5-11
Advertisement
Table of Contents
Troubleshooting
