Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual page 179

Check the current state of the Cisco 12012 using the show version command, which
displays the release of Cisco IOS software that is available on the Cisco 12012 and the
installed interfaces, as follows:
Router> sh version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-MZ), Released Version 11.2(8)GS [biff-bfr_112]
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled Mon 25-Aug-97 20:13 by biff
Image text-base: 0x60010900, data-base: 0x604FE000
ROM: System Bootstrap, Version 11.2(8)GS [biff-bfr_112], RELEASED
SOFTWARE
BOOTFLASH: GS Software (GSR-BOOT-M), Released Version 11.2(8)GS
[biff-bfr_112 1913]
Router uptime is 20 days, 12 hours, 16 minutes
System restarted by reload
System image file is "biff/gsr-p-mz", booted via tftp from 1.1.1.254
cisco GRP (R5000) processor (revision 0x00) with 65536K bytes of memory.
Processor board ID 00000000
R5000 processor, Implementation 35, Revision 2.1 (512KB Level 2 Cache)
Last reset from power-on
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Single-port OC12c ATM controller (1 ATM).
1 four-port OC3 POS controller (4 POS).
1 Ethernet/IEEE 802.3 interface(s)
1 ATM network interface(s)
4 Packet over Sonet network interface(s)
507K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0102
Router#
For additional interface configuration information, refer to the configuration notes that
accompanied your line cards. For more information on specific system configurations, refer
to the section "If You Need More Configuration Information," later in this chapter.
Observing System Startup and Performing a Basic Configuration 4-19
Configuring the Cisco 12012