Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual page 171

Step 3
Interface IP-Address
Ethernet0 unassigned
POS3/0 unassigned
POS3/1 unassigned
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Notice: NVRAM invalid, possibly due to write erase.
Note The first two sections of the preceding configuration script (the banner
and the installed hardware) appear only at initial system startup. On subsequent
uses of the setup command facility, the setup script begins with the following
System Configuration Dialog.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes/no]:
Note The examples in this section represent a continuation of the setup facility
or the setup command facility.
Enter yes or press Return when asked if you want to enter the configuration
dialog and if you want to see the current interface summary. Press Return to
accept the default (yes):
Would you like to enter the initial configuration dialog? [yes]:
First, would you like to see the current interface summary? [yes]:
In the following example of a yes response (during the setup facility), the partial
summary shows a Cisco 12012 system at first-time startup; that is, nothing has
been configured, and the following summary reflects this.
OK? Method Status
YES unset administratively down down
YES unset administratively down down
YES unset administratively down down
Observing System Startup and Performing a Basic Configuration 4-11
Configuring the Cisco 12012
Protocol