Use the following procedure to install and remove a Flash memory card:
Step 1
Facing the RP front panel, hold the Flash memory card with the connector end
of the card toward the slot and the label facing right.
Note
The Flash memory card is keyed and cannot be seated the wrong way.
The ejector button will not pop out if the card is not properly inserted.
Insert the card into the appropriate slot until the card completely seats in the
Step 2
connector at the back of the slot and the ejector button pops out toward you (see
Figure 4-2b).
Note that the card does not insert all the way inside the RP; a portion of the card
remains outside of the slot. Do not attempt to force the card past this point.
Step 3
To eject the card, press the appropriate ejector button until the card is free of the
connector at the back of the slot. (See Figure 4-2c.)
Step 4
Remove the card from the slot and place it in an antistatic bag to protect it.
Observing System Startup and Performing a Basic Configuration 4-35
Implementing Other Configuration Tasks