Table of Contents
Advertisement
•
The bootable Cisco IOS software image you want to copy to the Flash memory card
exists on a TFTP server to which you have access (meaning you know its name and have
connectivity to it), and at least one interface is available to access this server
To assure access to a TFTP server, you need to configure one interface using the setup
command facility. For instructions on using this facility, refer to the section "Performing
a Basic Manual Configuration Using the Setup Facility or the setup Command," earlier
in this chapter, or to the Configuration Fundamentals Configuration Guide publication.
•
You know the filename of the image you want to copy into the Flash memory card
Use the following procedure to copy a bootable image into the Flash memory card:
Boot the router and allow it to initialize.
Step 1
Step 2
Enable the router and copy the image new.image to the Flash memory card in slot
0, using the following series of commands:
Router> en
Password:
Router# copy tftp:new.image slot0:new.image
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCC
Router#
In the preceding example, the exclamation points (!!!) appear as the file is
downloaded, and the "C" characters signify calculation of the cyclic redundancy
check (CRC) value, which is a verification that the file has been correctly
downloaded to the Flash memory card. You must now reboot the system.
This completes the procedure for copying a bootable image into a Flash memory card.
Observing System Startup and Performing a Basic Configuration 4-43
Implementing Other Configuration Tasks
Advertisement
Table of Contents
Troubleshooting
