Configuring SNMP management
SNMP (Simple Network Management Protocol) service is configured in the
SNMP Settings page. This page is used for setting up read-only and read-
write communities:
Figure 24: SNMP Settings
Community strings are used for SNMP authentication purposes. It is
possible to allow or deny IP address groups from accessing TEW-212APBO
using SNMP. IP address and netmask combination 0.0.0.0/32 means "ANY"
IP address. It could be setup by a specified IP, ex 192.168.2.100/32, or by a
group, ex 192.168.2.0/24.
Hint: For security purposes, use only local IP addresses for Read/Write
access
Click on the "Reset" button to reset all page fields to their default values and
click on the "Save Settings" button to save the SNMP setting.
38