Table of Contents
Advertisement
Loopback Test
Figure 23: Loopback Test page
Loopback test is used for wireless link diagnostics. This page shows data
transfer rate between TEW-212APBO and endpoint device. This transfer
rate is measured by sending ICMP (Internet diagnostics protocol) stream to
the end point device. Data is refreshed every second.
To start Loopback testing, enter endpoint IP address in the "Endpoint IP
address" field and click on the "Start" button in the lower right corner of
the page. Status line will show last measured data transfer rate, and the time
when this data was received from the endpoint. To stop loopback-testing,
click on the "Stop" button.
Note: Due to the nature of this test, test data is stored in the web browser
applet area. Clicking the "Refresh" or "Back" buttons when test is running
will stop the test and clear the collected test data.
37
Advertisement
Table of Contents
