C
ontrol Panel
mounting screw
control panel cable
Figure 7-4. Control Panel Removal
To remove the control panel, follow these steps:
1. Remove the power supply.
2. Disconnect the control panel cable from the PANEL connector on the
system board (see Figure 7-7).
3. From inside the chassis, remove the mounting screw securing the con-
trol panel to the chassis.
4. Remove the control panel from the chassis.
When you reinstall the control panel, place the control panel between the tabs in
the chassis. Before reinstalling the power supply, be sure to route the control
panel cable under the retention tabs on the chassis wall.
cable retention tabs (2)
chassis tabs (3)
Removing and Replacing Parts on the Net PC Chassis
7-5